Search found 7 matches

by DriveAG2
Fri Jun 15, 2007 11:36 am
Forum: Automotive Discussions
Topic: Lunkenheimer Automobiles Cincinnati, OH
Replies: 4
Views: 7781

Hello Again, THe Cincinnati Historical Society has an exhaustive article on Lunkenheimer with a picture that could be, but not explicitly labeled as one of the two prototypes of 1902. Below is the link to the article. I hope that it is not too long. If it wraps, you may have to do some re-assembly o...
by DriveAG2
Fri Jun 15, 2007 11:17 am
Forum: Automotive Discussions
Topic: Lunkenheimer Automobiles Cincinnati, OH
Replies: 4
Views: 7781

Lunkenhimer Car

To the best of my limited resources (not including the Kimes-Clark book),

Lunkenheimer made only two cars, both in 1902 with two cylinders each and no cars in the period around 1910.

If someone with the Kimes-Clark book could add to this, it would be nice.
by DriveAG2
Sat Apr 14, 2007 10:16 am
Forum: Automotive Discussions
Topic: Stress Crack Repair, Brass Lamps
Replies: 2
Views: 7119

Hello All,

I just posted a reply to an article on this forum from 2003-2004 that addresses Lamp Repair nicely to bring it to the top.

First Reply to "Early Solar Brass"
How many other nuggets are down on page five of this forum? :?:
by DriveAG2
Sat Apr 14, 2007 10:12 am
Forum: Automotive Discussions
Topic: Early Solar Brass
Replies: 4
Views: 11684

Brass Lamp Repair

Hello All,

Searching long enough brings results. I am just posting a reply to bring this topic from 2003-2004 to the top of the Forum :D. It addresses my concerns quite nicely. Thanks
by DriveAG2
Sun Apr 08, 2007 4:02 pm
Forum: Automotive Discussions
Topic: Stress Crack Repair, Brass Lamps
Replies: 2
Views: 7119

Stress Crack Repair, Brass Lamps

Hello All, Is there a practical way to repair stress cracks on brass lamps? Is there a practical way to prevent stress cracks? I have tried brazing (a junk lamp to practice upon) but the base melts at about the same temperature as the braze. Maybe a lower melting point braze or silver solder would w...
by DriveAG2
Wed Mar 07, 2007 12:52 pm
Forum: Automotive Discussions
Topic: Cast Aluminum Runningboards
Replies: 2
Views: 6372

Cast Aluminum Running Boards

Soooooooo.... Who is the foundry that can handle long aluminum castings for running boards? :?:
by DriveAG2
Tue Aug 01, 2006 11:22 am
Forum: Automotive Discussions
Topic: Clutch Fluid?
Replies: 3
Views: 9403

Wet Clutch Fluid

Hello, I am very familiar with wet multi-plate clutches but not your particular model, so these are general comments. Given that you had a "grabbing" clutch with 90 Weight oil/grease, I suspect that the problem is not the oil. Are you sure that it is a multi-plate wet clutch? Too heavy of oil is man...