Metal Spinning

Get help and help others restore and enjoy driving/touring in horseless carriages
Post Reply
User avatar
MochetVelo
Posts: 301
Joined: Wed Nov 05, 2008 5:46 pm
Location: Pennsylvania

Metal Spinning

Post by MochetVelo » Mon Jun 09, 2014 5:11 am

Metal spinning is normally done on special lathes, but it is quite possible on a normal wood or metal lathe. It's commonly used for brass lamp parts. It may be worth a try if you want to save some money, and enjoy a challenge. Be sure your metal is fully annealed before spinning. It may be necessary to re-anneal it during the spinning process. For brass, you simply heat the metal to a red glow, then let it cool (dip in water, if desired). The spinning tools are made long so they fit under your arm for stability. Here's a good video:

https://www.youtube.com/watch?v=W7QB0-AlwtI

To learn more, Terry Tynan made some good DVDs. You can rent them at SmartFlix:

https://smartflix.com/store/video/480/M ... g-Workshop

Penn State Industries, in association with Terry Tynan, sells a spinning kit designed to fit any wood lathe with an 10" swing (swing being the largest diameter you can turn on a particular lathe).

http://www.pennstateind.com/store/MSSTA ... odpage=1MS (I have no association with them, but I might buy it!)


Phil

15max
Posts: 6
Joined: Sat Feb 22, 2014 2:32 pm

Re: Metal Spinning

Post by 15max » Wed Jun 11, 2014 5:57 am

Very nice video. Here is a link to making some E&J lamp burners: http://www.mtfca.com/discus/messages/25 ... 1326907131

Post Reply